Blog

A Guide to Installing a Toilet Flush

Installing the flush system in the toilet should be done with precision. Once the installation is complete, it is time for the bathroom suite designer to sit back and relax. With water-saving targets, the user ensures that the toilet flushes effectively. It’s up to you whether to refresh an old flush or get a new one altogether.

Click here to learn more about this topic at https://www.plumbersingapore.org/toilet-flush-installation/.

Removing the Old Flush Mechanism

Begin by turning off the water supply connected to the bathroom and draining the tank by flushing until there is no water left. An old towel or a bucket may also be placed beneath the attachment to the tank so that if more water is stuck inside, it will collect any moisture. After that, remove the tank cover and find out the flush unit.

Take the wrench or pliers and detach the flush valve from the water line by removing the screws holding that part. Remove the flushing equipment and carefully dispose of all outdated components, like flush handles, wax flanges, and valves. Wipe the water tank up inside as much as possible, making sure not even a piece of trash or hard water deposits are left inside to hold up and flush the new one.

Installing the New Flush System

Upon detaching the old system, it is time to move on to the new flush. To start:

Position the fresh flush valve in the tank to accommodate the opening at the bottom.

Secure the nuts so that the valve doesn’t pivot from its position, but do not attempt to tighten them too much as such may cause the porcelain to crack.

After installing the flush valve, ensure the flapper or the seal is fitted correctly.

Additionally, the handle comes last in its configuration as it is placed permanently on the side of the tank. The hole will then be threaded with the arm of the handle showing through it, and several nuts will be used to fasten it properly. The arms of the handle are connected to the chains that pull the flapper, setting the chain’s length taut so that the flapper and its hook open and close properly when the handle is pressed.

Click here to book professional services at https://www.plumbersingapore.org/our-services/.

Last, the water supply line must be connected to the flush valve, and the water must be switched back on. After it fills, try to flush by pressing the handle or hitting the button, waiting for the tank to stop. The installation is finished if all the water flows and the tank is full after flushing and does not leak.

After the flush is installed, the system should be checked for abnormal working operation. Do several flushes to check if the flapper closes and does not hinder the water flow. If the flush performance is not as strong as it should be, check the water level in the tank and turn the fill valve to the required position. For the toilet to achieve its best results, the water level inside the tank must be one inch below the overflow tube.

Testing

If you find any leaks around the flush handle or the flush valve itself, twist those parts a little more, but don’t revert too much, as it can break the parts. To avoid lengthy maintenance and repair work, the check system should be performed as soon as the system has been installed.

 

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button